Changing the paper – Printek FormsPro 4300 User Manual
Page 33
Operation
Page 3-13
CHANGING THE PAPER
This section assumes that you are familiar with the operation of the control panel buttons as
described in “Control Panel Buttons” earlier in this chapter.
Changing the Form in the Tractors
To unload the currently loaded paper or form, place the printer offline and press the
UNLOAD/FORM SELECT button. This positions the top of the paper in the tractors in the
base of the printer.
To open the case for access to the tractors, pull out on the bottom of the lower front panel of
the printer to release the latch as shown below:
Opening The Latch Panel.
While pulling out on this panel, lift the front of the printer to expose the paper tractors. The
top of the unit will support itself in the up position while you load paper.
Caution: Do not open the unit in this fashion while the
printer is printing or forms are loaded. Doing so may
cause data to be printed incorrectly or paper to jam
when the unit is closed. Refer to the section on Control
Panel Operation for instructions on unloading forms.