Printek FormsPro 4300 - Manual (Page 35)

Operation
Page 3-15
FormsPro 4503 With Forms in All Tractor Paths.
Center Path Positioned for Loading.
Close the case of the printer by lowering it until the lower front panel closes. The printer
LCD will display “Case Closed” when you do this.
Check the LCD to make sure the correct form setup (0-9) has been selected. If necessary,
press the UNLOAD/FORM SELECT button until the correct one is displayed.
Now press the LOAD/FORM FEED button to position the top of the paper at the tear bar.
The printer LCD will display “Load Paper” when you do this. After the paper is loaded, the
LCD will display the form number, and if a FormsPro 4503, the path.
Paper installation is now complete. Press the ONLINE button to place the printer back on-
line.
FormsPro 4503: Changing to a Form Installed in Another Path
To unload the currently loaded paper or form, first tear off any forms that have been printed.
Then take the printer offline and press the UNLOAD/FORM SELECT button. This positions
the top of the paper in the tractors in the base of the printer.
Press the UNLOAD/FORM SELECT button until the desired form and path are displayed on
the LCD. Then press the LOAD/FORM FEED button. The tractors will move to the
specified path (if necessary) and position the top of the selected form at the tear bar. Press
the ONLINE button to place the printer back into operation.