Printek FormsPro 4300 User Manual
Page 60
Optional Coaxial/Twinaxial Interface
Page C-2
In the DSC/DSE type LU3 mode, both formatted and unformatted data streams are supported.
Interface diagnostics are available at the end of this appendix in the section titled
“Coaxial/Twinaxial Interface Diagnostics”.
CX/TX Interface.
Option Switches When Configured for Coaxial Operation
The dipswitches as shown above have the following meanings when the interface is
configured for coaxial operation. An asterisk (*) indicates the factory default setting.
Switch/Position
Function
SW1-1 OFF*
Select IBM 3287 Emulation.
SW1-1 ON
Select IBM 3262 Emulation.
SW1-2 OFF*
Reserved for future use.
SW1-3 OFF*
Reserved for factory use.
SW1-4 OFF*
Reserved for factory use.
SW1-5 OFF*
Set default Maximum Print Position to 132
columns.
SW1-5 ON
Set default Maximum Print Position to none.
SW1-6 OFF*
Set default Maximum Print Line to none.
SW1-6 ON
Set default Maximum Print Line to 66 lines.
SW1-7 SW1-8
Parallel multiplexer timeout.
OFF*
OFF*
Short (15 seconds)
ON
OFF
Medium.