Panasonic KX-FT34HK - Manual (Page 17)

– 17 –
Setup
In
it
ia
l
P
re
p
a
ra
tio
n
Installing the recording paper
Note:
● Only use the included roll of paper or specified recording paper, or else the print quality may be affected
and/or excessive thermal head wear may occur.
● To order recording paper, see page 5.
● When the power cord is connected, everytime you close the cover a message will be printed. If the recording
paper is set to the wrong side, a message will not be printed. Install the paper correctly.
1
Open the cover by pressing the cover open
button and install the recording paper roll.
● If the paper is secured with glue or tape, cut
approximately 15 cm (6 inches) from the
beginning of the roll.
2 Insert the leading edge of the paper into the
opening above the thermal head and pull it out of
the unit.
● Make sure that there is no slack in the paper
roll.
3 Close the cover securely by pushing down on
both corners.
Cover open
button
Thermal head
correct incorrect
Installing the paper stacker
Install the paper stacker.
Paper stacker