Basic operations, Important, Switching the system on/off – Philips MCD300 User Manual

Page 16: Volume control

Advertising
background image

50

English

Basic Operations

IMPORTANT!

– Before you operate the system,
complete the connection procedures.
– When the system is switched to Standby
mode, it is still consuming power.To
disconnect the system from the power
supply completely, reomve the AC power

plug from the wall socket.

Switching the system on/off

Press STANDBY ONB (B on the remote).

HELLO” is displayed briefly. The system will

switch to the last selected source.

Press DISC, TUNER or AUX on the remote.

The system will switch to the selected source.

To switch the system to standby mode

Press STANDBY ONB (B on the remote).

The display shows “

BYE BYE” briefly, then

-- --:-- -- (if you haven’t set time) or the set time.
(See Setting the clock” on page 66.)

Helpful hints:
The interactive sound settings, last selected
source and tuner presets will be retained in the
player’s memory.

Volume control

Turn VOLUME (+/-) clockwise or anticlockwise
(or press VOLUME +/- on the remote) to
increase or decrease the volume level.

The display shows ”

VOL” and a volume value

from “1” to “30” (“

MIN” or “MAX” is displayed

when the volume level is adjusted to the lowest
or highest).

To listen through the headphone

Connect the headphone plug to the n socket
at the top of the system.

The speakers will be muted.

IMPORTANT!
– Adjust the volume to a moderate level
before you plug in the headphones.

To switch off the volume temporarily

Press MUTE on the remote.

Playback will continue without sound and

MUTE” flashes.

To activate sound reproduction, you can:
– press MUTE again;
– adjust the volume controls;
– change source.

p038-p071_MCD300_Eng

2005.11.3, 16:34

50

Advertising