Philips MCD300 - Manual (Page 31)

65
English
Tuner
Tuning to radio stations
1
Press STANDBY-ONB (or B on the
remote) to switch on the last selected source.
2
Press repeatedly SOURCE (or TUNER on
the remote) until FM or MW is displayed.
3
Press and hold TUNING 3 / 4 or TU +/- а /
б on the remote until the frequency in the
display starts changing.
➜ Display shows SEARC during automatic
tuning.
➜
After the system tunes to a station of
sufficient reception, display shows its frequency .
● To tune to a weak station, press briefly and
repeatedly TUNING
3 / 4 or TU +/- а / б
on the remote until an optimal reception is
found.
4
Repeat Step 3 if necessary until you find the
desired radio station.
Storing preset radio stations
You can preset up to 40 stations (20 in each
band) regardless of the reception.
Manual programmng
1
Tune to your desired radio station (refer to
“Tuning to radio stations”).
2
Press PROG on the remote.
➜ ” PROG” icon flashes.
3
Press PRESET 3/4 or CH +/- (¡ / ™) on the
remote to select the desired preset number.
4
Press PROG on the remote again to store the
radio station.
➜ ” PROG” disappears on the display.
● Repeat steps 1-4 to store other radio stations.
Helpful hints:
– You can erase a preset station by storing
another frequency in its place.
Autostore: automatic programming
Autostore automatically starts programming
radio stations from preset 1. Any previous
presets e.g. manually programmed will be erased.
● In tuner mode (FM or AM), press and hold
PROG until AUTO appears.
➜ During automatic programming, display shows
AUTO and flashing PROG.
➜ Available stations are programmed (20FM or
20 AM).
➜ After all stations are stored, the first autostore
preset station automatically plays.
Listening to preset radio stations
● In tuner mode, press PRESET 3/4 or CH +/-
( ¡ / ™) on the remote to select the desired
preset number.
➜ The preset number, radio frequency, and
waveband are displayed.
p038-p071_MCD300_Eng 2005.11.3, 16:34 65