Philips MCD300 - Manual (Page 8)

42
English
Connections
Connecting antennas
Connect the supplied AM/MW loop antenna and
FM antenna to the respective terminals. Adjust
the position of the antenna for optimal reception.
AM/MW Indoor Loop Antenna
●
Position the antenna as far as possible from a TV,
VCR or other radiation source.
FM Indoor Antenna
● For better FM stereo reception, connect an
outdoor FM antenna to the FM AERIAL (FM
ANTENNA) terminal.
Connecting a TV
You must connect a TV to your DVD micro
system in order to view the DVD/VCD playback.
IMPORTANT!
– There are various ways to connect the
system to a TV. You only need to make
one of the best connections, depending
on the capabilities of your TV system.
– If COMPOMENT video output jacks or
S-Video jack is used for video connection,
the system’s Component setting will need
to be set accordingly. Details are shown
under “Video Setup Page”.
●
Connect the VIDEO jack to the video input jack
on the TV using a video cable (yellow).
OR
Option 1
Connect the S-VIDEO output jack to the S-
Video input jack on the TV using an S-Video
cable (not supplied).
OR
Option 2
Use the component video cables (red/blue/
green) to connect the DVD micro system’s
COMPONENT video output jacks to the
corresponding component video input jacks (or
labeled as Pr/Cr Pb/Cb Y or YUV) on the TV.
IMPORTANT!
– The progressive scan video quality is
only possible when using Y Pb Pr and a
progressive scan TV is required. (Proceed
to page 47-48 for detailed Progressive
Scan setup.)
Note:
– To avoid magnetic interference, do not position
the front speakers too close to your TV.
Connecting the power cord
After everything is connected properly,
plug in the AC power cord to the power
outlet.
Never make or change any connection with the
power switched on.
1 2
Option 1
Option 2
TV
p038-p071_MCD300_Eng 2005.11.3, 16:34 42