Precor Low Impact M9.33 - Manual (Page 40)

Owner’s Manual: Advanced Programming and Troubleshooting 38
Selecting a U.S. Standard or Metric Display
The treadmill can display measurements in either U.S.
Standard (U.S. STD) or METRIC. The default factory setting
is set to display U.S. STD. To change this setting, perform
the following steps:
1. At the Precor banner, press the following keys in
sequence and without pause:
RESET, QUICKSTART, ENTER, SELECT [USER 2],
INCLINE
▲
As shown in Diagram 9, numbers are associated with the
keypad. The numbers 5, 6, 7, 1 appear on the display as
you press the associated key.
Diagram 9: Keypad programming numbers
2. SELECT UNITS appears, followed by the current unit of
measure (U.S. STD or METRIC). Use an arrow key to
switch between the options.
3. Press ENTER to accept the displayed setting.
The change will be retained in memory even if the
treadmill is turned OFF and unplugged.
4. To continue programming the treadmill to change
password protection, refer to Selecting Password
Protection.
5. If you want to end programming, press RESET.
1
4
5 3 7 6
8
9
2