Precor Low Impact M9.33 - Manual (Page 42)

Owner’s Manual: Advanced Programming and Troubleshooting 40
Informational Displays
The treadmill provides information about its use (odometer
and hour meter), as well as software version, error log, and
serial number. In general, you would only access this
information if directed to do so by Precor Customer Support.
These instructions guide you through all five informational
displays. Pressing the ENTER key moves you through the
displays. To exit, press the RESET key at any time.
Viewing the Odometer
1. At the Precor banner, press the following keys in
sequence and without pause:
RESET, ENTER, QUICKSTART
Numbers 6, 5 appear on the display as you press the
associated key.
Then MILES appears on the display followed by the
odometer value (the cumulative miles users have
traveled).
Note: If the unit of measure is set to metric, then
KILOMETERS appears instead of MILES.
2. When you are ready, press ENTER to move to the next
display (hour meter).
Viewing the Hour Meter
HOUR METER appears on the display followed by the
number of hours that the unit has been in use. The
treadmill tracks the elapsed minutes, but the value that
appears is truncated to the nearest full hour.
3. When you are ready, press ENTER to move to the next
display (software version).
Viewing the Software Version and Part Numbers
SW VERSION appears on the display followed by the
upper board software version and part number (for
example, 47475-205).
4. To see the lower board’s serial number and upper boot
part number, use either SELECT key. If needed, you can
move through all three—upper board, lower board, and
upper boot—using the SELECT keys.
5. Write the numbers in the space below. You will need
these numbers when you call Customer Support with
display-related questions. This information will help rule
out any software-related problems:
Upper Board P/N: ___________________
Lower Board P/N: ___________________
Upper Boot Software P/N: _____________