Primera Technology CX1200 - Manual (Page 20)

16 Load Label Stock
C. Immediately after the label stock is attached, engage the Rewinder by flipping the Rewinder
Dancer Arm toward the printer until it touches the paper.
Important! To minimize the slack loop that will be created under the rewinder, it is very important that you
engage this lever immediately after the label stock is taped to the core.
The taping process occurs very quickly so you may not get the label stock attached correctly the first
time you try it. It is important to attach the label stock centered on the core. If the attached label
stock is too far to the right or left the paper may fold over itself and cause an uneven wrap. If you
think the label stock was not attached properly, cancel the print job using the control panel on the
front of the printer.
Note: Use the Potentiometer on the top of the rewinder to increase or decrease tension to get a tighter or
looser wrap. If the stock is slipping through the clamp in the tensioning unit, you may need to decrease
the tension.
Figure 4-9.
Figure 4-10.
Warning! Keep loose
fitting clothing such
as ties and shirt
sleeves away from
the rewinder once it
has been engaged.
!
Tensioning Unit
Potentiometer
TOC INDEX