Panasonic BL-WV10 - Manual (Page 18)

Getting Started
18
3. Connect the camera to the power outlet.
4. Wait while the Quick Setup utility restarts, configures, and registers the
camera.
• When the camera has been configured and registered, [Finished] is
displayed next to the camera name ([CAM1], for example) and the buzzer
sounds.
• If [This camera’s firmware is out of date] is displayed, you must update the
camera’s firmware. Refer to the information on page 6. It is also
recommended that you erase the camera (see “Erasing a Camera” on
page 104 of the Operating Instructions) and then register it again.
5. To register another camera, connect the camera to one of the LAN jacks of
the BL-WV10, then turn the camera on by connecting it to the power outlet.
6. When you have finished registering all cameras, set the BL-WV10’s mode
switch to NORMAL, disconnect the DC cord from the rear of the unit,
Ethernet cable
LAN jacks Rear panel of
BL-WV10
Bottom of BL-C30
Rear panel
of camera
To
power
outlet
BL-WV10_GS-en.book Page 18 Wednesday, January 25, 2006 5:18 PM