Pioneer VSX-D908TX - Manual (Page 15)

15
Connecting Your Equipment
PREP
ARA
TION
First turn the receiver off, then press the power button
while holding down the SPEAKERS button.
Choose the impedance setting by pressing the SPEAKERS button again.
You can choose the 8
Ω
-16
Ω
setting or the 6
Ω
-8
Ω
setting.
To check which impedance the amplifier is set to hold down
the SPEAKERS button for 2-3 seconds. You willl get a display
like the one shown below right telling you the speaker
impedance setting.
7 Speaker terminals
1 Twist exposed wire
strands together.
2 Loosen speaker
terminal and insert
exposed wire.
3 Tighten terminal.
10 mm
Speaker impedance
You can change the speaker impedance to suit the kind of speakers you have in your home system but we
recommend using speakers with an impedance of 8
Ω
-16
Ω
(the default setting). If you are using 6
Ω
-less than
8
Ω
impedance speakers, you need to change the impedance setting.
(This display indicates an 6
Ω
-less than
8
Ω
impedance setting)
(This display indicates a 6
Ω
-less
than 8
Ω
impedance setting)
or
(This display indicates an 8
Ω
-16
Ω
impedance setting)
dB
SIGNAL
SELECT
ANALOG SP A
VOLUME
dB
SIGNAL
SELECT
ANALOG SP A
VOLUME
dB
SIGNAL
SELECT
ANALOG SP A
VOLUME
STANDBY/ON DSP MODE
THX CINEMA ADVANCED STANDARD
STANDBY
AUDIO/VIDEO MULTI-CHANNEL RECEIVER Digital S
STEREO
/DTS
PHONES S-VIDEO
5-CHANNEL EQUAL POWER OUTPUT
VIDEO
EXTERNAL DECODER IN DIRECT LOUDNESS MIDN
SPEAKERS – – BASS +
L AUDIO R VIDEO INPUT
MPEG
SPEAKERS
w STANDBY/ON
VSX-D938TX