Pioneer VSX-82TXS-S - Manual (Page 67)

Using other functions 10
67
En
Making an audio or a video recording
You can make an audio or a video recording from the
built-in tuner, or from an audio or video source
connected to the receiver (such as a CD player or TV).
1
Keep in mind you can't make a digital recording from an
analog source or vice-versa, so make sure the
components you are recording to/from are hooked up in
the same way (see
Connecting your equipment on
page 10 for more on connections).
Since the video converter is not available when making
recordings (from the video
OUT jacks) make sure to use
the same type of video cable for connecting your recorder
as you used to connect your video source (the one you
want to record) to this receiver. For example, you must
connect your recorder using S-video if your source has
also been connected using S-video.
For more information about video connections, see
Connecting a DVD/HDD recorder, VCR and other video
sources
on page 13.
1 Select the source you want to record.
Use the input source buttons (or INPUT SELECT ).
• If necessary, press SIGNAL SELECT to select the
input signal corresponding to the source component
(see
Choosing the input signal on page 30 for more
on this).
2 Prepare the source you want to record.
Tune to the radio station, load the CD, video, DVD etc.
3 Prepare the recorder.
Insert a blank tape, MD, video etc. into the recording
device and set the recording levels.
Refer to the instructions that came with the recorder if
you are unsure how to do this. Most video recorders set
the audio recording level automatically—check the
component's instruction manual if you're unsure.
4 Start recording, then start playback of the source
component.
Playing a different source when recording
Using this receiver, it’s possible to listen to a different
source than the one you’re recording.
1 During recording, press the REC SELECT CONTROL
button on the front panel until RECOUT shows in the
display. 2
2 While RECOUT shows in the display, use the
INPUT SELECTOR dial to select the source you want
to record.
The default, RECOUT SOURCE , records the source you’re
currently listening to (as in Making an audio or a video
recording above).
Contrast Adjusts the contrast between light
and dark. –10 to +10
Default: 0
Hue Adjusts the red/green balance. –10 to +10
Default: 0
Resolution e Specifies the output resolution of the
video signal (select this according to
the resolution of your monitor and
the disc you wish to watch). PURE
480p
720p
1080i
Aspect Specifies the aspect ratio of an
analog video signal (if the image
doesn’t match your monitor type,
cropping occurs as indicated in
parentheses at left). THROUGH
(none)
4:3 (left/right)
ZOOM
(top/bottom)
a. Only when listening to 2-channel sources in Dolby Pro Logic IIx Music
mode (also available with
2 Pro Logic II 5.1 channel sound).
b.Only when listening to 2-channel sources in Neo:6 Music mode.
c. You shouldn't have any problems using this with most SACD discs, but
if the sound distorts, it is best to switch the gain setting back to
0 dB.
d. When THROUGH is selected, the Resolution is automatically set to
PURE (regardless of the setting).
e. There are cases where (depending on the resolution of the video signal
and your monitor) you may not be able to see a picture after selecting a
resolution setting. If this happens, select a different resolution setting.
Note that analog input signals are unaffected when using the
720p and
1080i resolution settings.
Note
1 • The receiver's volume, AV parameters (the tone controls, for example), and surround effects have no effect on the recorded signal.
• Some digital sources are copy-protected, and can only be recorded in analog.
• Some video sources are copy-protected. These cannot be recorded.
Setting What it does Option(s)
2 If RECOUT does not appear in the display, you may have to switch ROOM 2 off by pressing MULTI ROOM & SOURCE ON/OFF and selecting either
ROOM 3 or off (the MULTI-ROOM indicator disappears). See Using the multi-room controls on page 59 for more on this.
RECEIVER SOURCE
SYSTEM OFF
INPUT
SELECT
DVD SAT VIDEO 1 TV CONT
DVR1 i Pod TUNER RECEIVER
CD
DVR2 CD-R
TV VIDEO 2
XM RADIO ROOM2/3
SPEAKERS (TUNE +)
ENTER
(TUNE –)
PHONES
AV
PARAMETER
SETUP
(ST –) (ST +)
TUNER
EDIT
BAND
CONTROL ON/OFF
VIDEO
SELECT
SIGNAL
SELECT SBch
PROCESSING STEREO
VIDEO/GAME 2 INPUT
DIGITAL IN S-VIDEO VIDEO L R AUDIO
MULTI – ROOM &
SOURCE/REC SEL
MCACC
SETUP MIC
RETURN
VSX_84TXSi.book.fm 67 ページ ２００６年３月１３日 月曜日 午前１１時５４分