Pioneer VSX-82TXS-S - Manual (Page 69)

Using other functions 10
69
En
Checking your system settings
Use the status display screen to check your current
settings for features such as surround back channel
processing and your current MCACC preset.
1 Press STATUS to check the system settings.
These appear on both the OSD and the front panel
display.
1
The front panel display shows each of the following
settings for two seconds each:
2 When you’re finished, press STATUS again to
switch off the display.
Resetting the system
Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the front panel AV
PARAMETER button, press and hold STANDBY/ON
for about three seconds.
The display shows RESET? .
3 Press the front panel ENTER button.
The display shows RESET OK? .
4 Press SETUP to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.
Default system settings
Note
1 If the Pure Direct mode is switched on, some settings above will show OFF , even though they are on.
Input source Listening mode
Signal select Surround Back Processing
Sound Retriever Video Select
MCACC Position Room 2 / REC SEL
Room 3
SHIFT
STATUS
MCACC S.DIRECT
MULTI OPE
SIGNAL SEL
PHOTO
SBch STEREO
AUDIO SUBTITLE
ADV. SURR STANDARD
PHASE
THX
HDD
CH CH
DVD
DISP
STATUS
96kHz STEREO
Signal Select
: AUTO
SBch Processin : OFF
Retriever
: ON
Video Select : OFF
MCACC Position : M1
Room2/REC SEL : SOURCE
Room3
: SOURCE
Setting Default
HDMI Audio Amp
Digital Video Conversion On
Speakers A
Surround Back System Normal (SBch)
Speaker System Front SMALL
Center SMALL
Surr. SMALL
SB SMALLx2
SW YES
Crossover 80 Hz
Bass Peak Level OFF
X-Curve OFF
THX Audio Setting 0–1ft.
Inputs
See Input function default and possible settings on page 64.
Multi Room
Room 2 Volume Type Variable
Room 2 Volume -60
SR+
SR+ Control On/Off OFF
SR+ Volume Control On/Off OFF
Monitor Out OFF
DSP
MCACC Position Memory M1: MEMORY 1
Surround back channel
Processing ON
Phase Control On
Sound Retriever Off
Sound Delay 0 frame
Dual Mono CH1
DRC OFF
SACD Gain 0 dB
Digital Safety OFF
Effect Level 7 ch Stereo 90
Other modes 50
VSX_84TXSi.book.fm 69 ページ ２００６年３月１３日 月曜日 午前１１時５４分