Selecting the language, Determining the units of measure, Reset, resistance ▼, ▲, ▼, reset , resistance – Precor Commercial EFX EFX546 User Manual
Page 18
page 18
C
O
M
M
E
R
C
I
A
L
P
R
O
D
U
C
T
S
D
I
V
I
S
I
O
N
To access the Club settings, the following must occur:
❑ Check to be sure that the EFX is turned ON.
❑ Check that the Precor (or club) banner appears on the display.
❑ Press the appropriate key sequences.
Important: To access Custom mode, press Reset while the Precor banner is dis-
played. Within 1/2 second, begin pressing the key sequences. If the system does
not detect a key press (within 1/2 second) after Reset, it returns to the banner. Once
you begin entering a key sequence, each key must be pressed within 4 seconds of
the other or the Precor banner reappears and you have to begin again.
Display key functions within the Club Custom Mode
Reset
exits Club Custom mode and
displays the Precor banner.
Note: The touch sensitive keys can be gently pressed and held to view several
selections. The longer the key is held down, the faster the numbers scroll past.
Important: Remember to begin at the Precor banner. After pressing the Reset
key, you must press the next key in the sequence within 1/2 second, or the
Precor banner reappears and you have to begin again.
The display console keys that you need to press to change the language, select
the units of measure, set the maximum workout and pause times are as follows:
Reset, Resistance
▼, ▲, ▼, Reset, Resistance ▼, ▲, ▼
Note: The
▼
and
▲
symbols shown above represent the Resistance keys. Do not
use the Cross Ramp
▼▲
keys to attempt access to the Club custom mode.
SELECTING THE LANGUAGE
Display prompts can appear in English, German, Spanish or French. Use the
▼▲ keys to make your choice and press Enter to select it.
Note: The functions of the display console keys while in Club Custom mode are
described in the box above.
DETERMINING THE UNITS OF MEASURE
Two different units of measure can be selected,
Metric or U.S. standard. Make your
selection using the
▼▲ keys. Press Enter once the correct unit is displayed.
Note: Anytime you wish to exit the Club Custom mode, press the Reset key.
Any previous display attributes that you selected by pressing Enter are saved
and recorded in memory.
▼▲
lets you scroll through the
various selections that appear.
Enter
saves the information being
displayed and moves to the
next aspect of the program.