Panasonic DMR-EZ47VEB - Manual (Page 77)

77
RQT8857
Cannot operate the TV with unit’s
remote control.  Change the manufacturer code on the remote control. 65
 It may be necessary to set the code on the remote control again after
changing the batteries.
75
Cannot operate the DVD.  Press [DRIVE SELECT] to select the DVD drive when operating DVDs or
CDs.
13
Cannot operate the VHS.  Press [DRIVE SELECT] to select the VHS drive when operating video
cassettes.
13
The remote control doesn’t work.  The remote control code is wrong. Change to the correct code. 75
 The batteries are depleted. Replace them with new ones. 5
 Point the remote control at the remote control sensor on the main unit. 5
 Remove obstacles between the remote control and the main unit. −
 Remove dust from the transmission window and the unit’s sensor. −
 Coloured glass may obstruct the signal reception/transmission. −
 Don’t place the signal sensor in direct sunlight or in areas that may be
subject to sun exposure.
−
 It may be necessary to set the manufacturer code again after changing the
batteries.
65
 The Child Lock function is activated. 65
The unit is on but cannot be
operated.  Recording drive or playback drive has not been selected properly. 13, 14
 Some operations may be prohibited by the disc. −
 The unit is warm (“U59” appears on the unit’s display). Wait until “U59”
disappears.
89
 One of the unit’s safety devices may have been activated.
Reset the unit as follows:
Press [
/I] on the main unit to switch to standby mode,
If the unit doesn’t switch to standby mode, reset the unit ( ¼ 75, “To restore
the unit if it freezes”).
 The unit cannot be operated while performing an update. “SW-DL” appears
on the unit’s display while it is updating. Please wait until the “SW-DL”
disappears.
−
64
“U88” is displayed and the disc
cannot be ejected.  The unit is carrying out the recovery process. The disc may be defective.
Do the following to eject the disc. Try another disc.
(1) Press [
/I] on the main unit to switch to standby mode.
If the unit doesn’t switch to standby mode, reset the unit ( ¼ 75, “To
restore the unit if it freezes”).
(2) While the unit is turned off, press and hold [ ] and [CH ] on the main
unit at the same time for about 5 seconds. (Ejection may take extra
time depending on discs.)
−
Cannot eject a disc.  The unit is recording. −
 The unit may have a problem. Eject the disc as in (2) above.
 Linked timer recordings with external equipment is in recording standby
(“EXT-L” on the unit’s display blinks when [ DVD/VHS] is pressed.) Press
[EXT LINK] to cancel the recording standby.
If the Child Lock function is activated, above operation does not work.
Cancel the Child Lock function.
−
23, 65
Startup is slow.  Startup takes time in the following situations:
– A disc other than a DVD-RAM is inserted.
– The clock is not set.
– Immediately after a power failure or the AC mains lead is connected.
– When the unit is connected with an HDMI cable.
 When “Power Save” is set to “Off”, startup becomes faster than when
“Power Save” is “On”.
−
64
General Issues Operation
Page
Ref
erence