Panasonic PV-D4735S - Manual (Page 32)

32 For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at:http://www.panasonic.com/contactinfo
Tape Operation (continued)
DETECTING TAPE POSITION
To find out the present tape position and amount of tape
remaining.
1
• “DETECTING TAPE POSITION”
only appears the first time a
cassette is inserted and it takes
several seconds for correct
indication to appear.
• The present tape position
indication and amount of tape
remaining (according to tape
speed) are displayed.
Tape remaining time display may
not be precise.
Tape Position Display
Press TAPE POSITION
to detect current tape position.
Tape position is displayed incorrectly in the following cases:
• If VHS-C type cassettes, tapes under 30 minutes, tapes
over 180 minutes, or incompatible tapes are used.
• If the correct tape length is not selected.
(See “Tape Select” section above.)
Tape Select
Select your tape length so the tape position and amount
of tape remaining are properly displayed.
(See “Tape Position Display” section below.)
3
2
1 Press ACTION
to display MENU.
Press to select
“SET UP VCR,” and
press SET.
Press ACTION
to return to normal screen. 4
Press to select “TAPE
SELECT,” and press SET
to set
“T-120,” “T-160” or “T-180.”
• Select “T-120” for tapes 120 minutes or less,
“T-160” if 140 or 160 minutes, and “T-180”
if 180 minutes.
T-120 T-160 T-180
Press TAPE POSITION
(or wait 5 seconds) to return to normal screen. 2
*Important: If a remote control button does
not work when pressed, press
the VCR button on the remote
and try the button again.
ACTION
SET
SELECT
TAPE
POSITION