Panasonic PV-D4735S - Manual (Page 53)

53
Audio Output (DVD only)
Select the digital output to be output from the optical
digital audio output connector of DECK.
■ ■ ■ ■ ■ “LPCM (DVD)” selections
OFF: Linear PCM of less than 48 kHz/16 bit is
output. When playing DVDs recorded in linear
PCM of over 48 kHz/20 bit, no digital audio is
output. (Factory preset)
PCM: When playing DVDs recorded in linear PCM
of 48 kHz/20 bit/24 bit or more, digital audio
converted to 48 kHz/16 bit is output.
(Digital output of PCM audio is restricted to
48 kHz/16 bit or below for copyright
protection.)
■ ■ ■ ■ ■ “Dolby Digital” selections
Bitstream: Dolby Digital bitstream (1 ch - 5.1 ch)
is output. (Factory preset)
PCM: When you have connected an amplifier that
doesn’t have a built-in Dolby Digital decoder.
■ ■ ■ ■ ■ “dts” selections
Bitstream: DTS bitstream is output. (Factory preset)
PCM: When you have connected an amplifier that
doesn’t have a built-in DTS decoder.
■ ■ ■ ■ ■ “DRC (Dynamic Range Compression)”
selections
OFF: Normal audio range is selected. (Factory preset)
ON:
For dynamic sound even at low volume,
this is useful for late-night listening.
[Dolby Digital DVDs only].
Press
to select an item,
and
press
SET
repeatedly for
output. (See below.)
Press
to select
“AUDIO OUTPUT,”
and
press
SET
to display screen.
1
3
2
Recommended setting
LPCM
( DV D )
P C M
P C M
P C M
D o l b y
Digital
PCM* 1
Bitstream
Bitstream
D T S
PCM* 1
P C M
Bitstream
No amplifier is
connected
AV amplifier (with
digital audio input
connector) without
Dolby Digital/DTS
decoder
AV amplifier
including Dolby
Digital decoder
AV amplifier
including Dolby
Digital/DTS
decoder
* 2
Type of amplifier
to be connected Press ACTION
to display DVD MAIN MENU.
Ready Checklist
DECK is in DVD mode, press DVD.
*Important: If a remote control button does not work when pressed,
press the DVD button on the remote and try the button again.
• Make settings according to amplifier
connected to optical audio output as shown
in above table.
*1 When connecting an amplifier (with an
optical digital input connector) which does
not contain the Dolby Digital or DTS
decoder, be sure to select “PCM”.
If “Bitstream” is selected, starting DVD
play may cause such a high level of noise
as to be harmful to your ears and damage
the speakers.
*2 When a dts decoder is connected, please
select “Bitstream” in “dts.”
If “PCM” is selected, there will be stereo
sound.
When a Dolby Digital decoder is
connected, please select “Bitstream” in
“Dolby Digital.”
If “PCM” is selected, there will be stereo
sound.
4 Press ACTION to redisplay DVD MAIN
MENU and go to step 2 to setup another
item.
Or, press
ACTION twice to exit.
DVD Operation