Panasonic SC-DK20 - Manual (Page 6)

Before use
RQT6345
6
✔ . . . . . . . ✕ . . . . . . .
TV type
Multi-
system TV
NTSC TV
PAL TV
Disc
PAL
NTSC
PAL
NTSC
PAL
NTSC
TV Monitor
For the Middle East, South
Africa, Australia and N.Z.
✔
✔ 1
✕
✕
✔
✔ 2
Disc information
Type of disc for the type of TV
DVDs and Video CDs are recorded using either PAL or NTSC.
For Australia, N.Z., the Middle East, South Africa and Asia
Refer to this table when selecting discs.
Example of how the picture appears on the screen
For Asia
✔
✔
✕
✔ 3
✔
✔ 4
1 If you select “NTSC” in “NTSC Disc Output” ( ➡ page 50), the pic-
ture may be clearer.
2 The factory preset for “NTSC Disc Output” is “PAL60”, so no
changes to the settings are necessary.
(If your television is not equipped to handle PAL 525/60 signals
the picture will not be shown correctly.)
3 The factory preset for “NTSC Disc Output” is “NTSC”, so no
changes to the settings are necessary.
4 Select “PAL60” in “NTSC Disc Output” ( ➡ page 50).
(If your television is not equipped to handle PAL 525/60 signals
the picture will not be shown correctly.)
For U.S.A., Canada and Latin America
The unit can playback only NTSC system discs.
Note
The bottom part of the picture may be cut off if the Video CD played
does not comply with standards.
Disc symbols used in these operating instruc-
tions
The functions you can use depend on the type of disc you
play. These marks are used to indicate which type of disc is
available for use.
: Feature can be used with DVD-Video
: Feature can be used with Video CD
CD : Feature can be used with Audio CD
Playing DVDs and Video CDs
The producer of the material can control how these discs are
played. This means that you may not be able to control play of
a disc with some operations described in these operating in-
structions. Read the disc’s instructions carefully.
To prevent damage
Always observe the following points.
• Load only 1 disc per tray.
• Load discs as shown in the figure.
An adaptor is not needed with 8 cm discs (singles).
• Set the system on a flat, level surface.
• Always unload all discs before moving the unit.
Do not;
• set the unit on top of magazines, inclined surfaces, etc.
• move the unit while a tray is opening/closing, or when loaded.
• put anything except discs in trays.
• use cleaning discs or discs which are badly warped or cracked.
8cm disc
12cm disc