Panasonic SC-DK20 - Manual (Page 9)

9
Simple set-up
RQT6345
FM indoor antenna
Twist the vinyl tip and pull off.
Fix the other end of the antenna where reception is
best.
For areas except U.S.A., Canada, Australia and N.Z.
Set the voltage before connection
(
➡ below).
AC power supply cord
For areas except U.S.A., Canada, Australia, N.Z. and Asia
If the power plug will not fit your socket, use the power plug adap-
tor (included).
Note
The included AC power supply cord is for use with this unit only.
Do not use it with other equipment.
Conserving power
The unit consumes power even when it is turned off with [POWER
f /I] ([ f /I]). To save power when the unit is not to be used for a
long time, unplug it from the household AC outlet. Remember to
reset the radio stations and any other memory items before using
the unit again.
U.S.A. and Canada: 0.25 W
Australia and N.Z.: 0.6 W
Others: 0.8 W
For your reference
Information you enter into the unit’s memory, except for time, re-
mains intact for up to a week after the AC power supply cord is
disconnected.
AM loop antenna
Twist the vinyl tip and pull off.
Stand the antenna up on its
base.
Keep loose antenna cord away
from other wires and cords.
Voltage setting
For areas except U.S.A., Canada, Australia and N.Z.
Use a flat-head screwdriver to turn the voltage selector to the appropriate posi-
tion for your area.
127 V ↔ 110 V ↔ 220 V-230 V ↔ 240 V
If the power supply in your area is 115 V or 120 V, please set the voltage selec-
tor as follows.
For 115 V: Set to 110 V.
For 120 V: Set to 127 V.
Note that the unit will be seriously damaged or fail to operate correctly if this
setting is not made correctly.
Antennas and AC power supply cord STEP
3
Adhesive tape
VOLT ADJ
220
I V
230
To household
AC outlet