Panasonic Pod9cw - Manual (Page 6)

- 6 -
2. Tilt and height adjustments can be made using the two screws
located on the upper portion of the fixed camera bracket. Loosen-
ing the screws allows the bracket itself to slide up and down the
bracket arms (height adjustment) and back and forth on the cam-
era bracket (tilt). Adjust to the desired location (Figure 4).
3. The camera can also be adjusted back and forth via the slot
located on the bottom of the bracket (Figure 5).
4. Attach the camera to the bracket using the 1/4-20 hex bolt
provided. Make final adjustments and lock down the pan, tilt, and
height adjustment screws (Figure 7).
Figure 4
Figure 5
Figure 7
Tilt
adjustment
screw
1/4-20 hex bolt
NOTE: A 90˚ BNC connector is included in the
packet to assist in fitting the camera (Figure 6).
Figure 6
IMPORTANT NOTE: Put the dome in place to assure the camera
does not touch it. To reattach the dome you must twist it, if the
dome comes in contact with the camera its position could change.
INSTALLING FIXED CAMERA BRACKET (ALL MODELS)
1. Loosen the two pan adjustment screws and rotate the bracket to
the desired viewing location.
Figure 3
Pan
adjustment
screw
Pan
adjustment
screw