Panasonic SV-AP10U - Manual (Page 8)

Preparation
8
Inserting Remote Control Batteries
1 While pressing the indentation A in the
direction indicated by the arrow, lift the
cover up.
2 Insert the batteries (supplied) with the
polarity (
+ and - ) correctly aligned.
3 Cover is returned.
Precautions for Battery Replacement
The service life of the batteries is approximately 1 year.
However, it varies considerably depending on the
frequency of use.
≥When they are exhausted, replace them with two AA,
UM3, or R6 size batteries.
≥When the batteries are exhausted, remove them
immediately and dispose of them correctly.
≥Make sure that the batteries are inserted with the
polarity ( + and - ) correctly aligned.
≥Do not mix old battery with new battery.
≥Do not mix different battery types, i.e. Alkaline and
Manganese.
≥Do not use rechargeable (Ni-Cd) batteries.
≥Do not heat or short-circuit the batteries.
≥When you do not use the remote control for a long time,
take out the batteries and store them in a cool, dry
place.
Using the Remote Controller
1 Direct the remote controller at the remote
control receiver
A and press a button on
the remote controller.
≥Distance from the Photo Printer: Within approximately
23 feet (7 m)
≥Angle: Within approximately 40 degrees in the vertical
direction and 60 degrees in the horizontal direction from
the central axis
≥Do not put an the obstruction between the Photo Printer
and remote controller.
≥Do not expose the remote control receiver to direct
sunlight or strong light.
≥When attaching the paper cassette, you cannot use the
remote controller from the right angle or lower right
angle.
≥The receiver range reverses between the Vertical and
Horizontal layout.
CAUTION
Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to the
manufacturer’s instructions.
A
+
+
-
-
A
AP10U-Eng.book 8 ページ ２００２年９月２７日 金曜日 午前１０時８分