Panasonic CQ-VX2200W - Manual (Page 26)

32
CQ-VX2200W
23
E
N
G
L
I
S
H
WARNING
This installation information is designed for experienced installers
and is not intended for non-technical individuals. It does not contain
warnings or cautions of potential dangers involved in attempting to
install this product.
Any attempt to install this product in a motor car by anyone other
than qualified installer could cause damage to the electrical system
and could result in serious personal injury or death.
❏ Overview
This product should be installed by a professional.
However, if you plan to install this product yourself,
your first step is to decide where to install it. The
instructions in these pages will guide you through
the remaining steps: (Please refer to the “WARN-
ING” statement above).
¡Identify and label the car wires.
¡Connect the car wires to the wires of the power
connector.
¡Install the unit in the dashboard.
¡Check the operation of the unit.
If you encounter problems, please consult your
nearest professional installer.
Caution: This unit operates with a 12 volt DC nega-
tive ground auto battery system only. Do not attempt
to use it in any other system. Doing so could cause
serious damage.
Before you begin installation, look for the items on
the right which are packed with your unit.
¡Installation Hardware …… Needed for in-dash
installation
❏ Installation Hardware
No. Item Q'ty
q Binding-Head Screws (5 mm
φ × 8 mm) 4
w Flat-Head Screws (5 mm
φ × 8 mm) 8
❏ Required Tools
You’ll need a screwdriver, a 1.5 volt AA battery, and
the following:
❏ Dashboard Specifications
THICKNESS
MIN. 4.75 mm
MAX. 5.56 mm
182mm
103 mm
12 V DC
Test Bulb
Electrical
Tape
Side-Cut
Pliers
Installation Guide