Pioneer DVR-745H-S - Manual (Page 43)

Recording 05
43
En
• Standby – The recorder is in timer
recording standby.
• nothing displayed – Another timer
recording or copying is in progress.
6 To exit the timer recording screen,
press HOME MENU.
Tip
• To enter a title name for the timer
recording in advance, select Set Title
Name and follow the on-screen display.
Note
• If you set a DVD timer recording but
there is no recordable DVD disc loaded,
or the disc loaded doesn’t have enough
free space for the complete recording,
Recovery is shown. In this case (unless
you load a suitable disc before the
recording actually starts), the recorder
will use the HDD for recording. (The
message
Can’t Rec will appear if there
are already 999 titles on the HDD or if
there is not enough free space on the
HDD for recording.)
• For a DVD timer recording, if Optimized
Rec (see Optimized Rec on page 112) is
set to On , the recorder will adjust the
recording quality to try and fit the
recording on the disc. If the recording
will not fit onto the disc even on
MN1
( MN4 for DVD+R/+RW) recording
quality then the Recovery Recording
feature will automatically make the
recording to the HDD instead.
• If there is very little free space left on the
HDD, an Auto Replace Recording may
not complete successfully.
• If the HDD is being used for playback or
high-speed copying when an Auto
Replace Recording is due to start, the
new timer recording will not replace the
old one. However, the next time the timer
recording starts, both of the older two
programs will be erased.
Editing a timer program
You can change any of the settings in a timer
program before the recording is due to start.
1 Press TIMER REC.
2 Highlight the timer program you
want to change
....
3 Press then select ‘Modify’ from the
command menu panel.
Alternatively, press ENTER .
The Timer Program Set screen appears from
which you can edit the settings.
4 Edit the timer recording settings as
necessary.
5 Select ‘Store Program’ to finish.
Confirm the settings you made from the
following screen.
Deleting a timer program
You can delete timer programs you no longer
need.
1 Press TIMER REC.
2 Highlight the timer program you
want to erase ....
3 Press then select ‘Erase’ from the
command menu panel.
• Select Yes to confirm or No to cancel.
• You can also just press CLEAR when the
timer program is highlighted.
DVR745H_IBD_EN.book 43 ページ ２００６年７月２７日 木曜日 午後４時１１分