Parker Hannifin PA Series - Manual (Page 19)

Chapter 2: Installing the PowerStation Installing the PA PowerStation
PA PowerStation User Guide
2-8
3
Slide the feet of the mounting clip into the larger portion of the slot,
then slide the clip over to properly mount the unit.
4
Tighten each of the mounting screws against the front of the
enclosure.
5
For 5” and 6” units: Torque them down to 6 in/lbs.
For 8” and 15” units: Torque them down to 7in/lbs.
For 10” units: Tighten so that the gasket seal maintains a 50%
compression of the gasket. You may see a small gap between the
bezel and the enclosure.
6
Tighten the screws in a crosswise sequence to ensure a good seal
and prevent damage. Tightening the bracket assembly may not
ensure that the gasket seal is totally depressed by the bezel. You
may see a small gap between the bezel and the enclosure.