Philips Avent SCD525 - Manual (Page 11)

- Radio interference is inevitable and may have an effect on the sound quality of the baby monitor.
- This baby monitor is intended as an aid. It is not a substitute for responsible and proper adult
supervision and should not be used as such.
- Take every precaution to make sure that your baby can sleep safely.
- The temperature sensor only measures the temperature in the baby room. It cannot be used
to control or adjust the temperature in the baby room.
- This monitor is not intended to be used as a medical monitor and its use should not replace
adult supervision.
preparing for use
Baby unit
You can use the baby unit corded or on non-rechargeable batteries. Even if you are going to use the
unit corded, we advise you to insert non-rechargeable batteries. This guarantees automatic back-up
in case of power failure.
Corded operation
1 Put the large appliance plug in the baby unit and put the adapter in a wall outlet (Fig. 4).
Operation on non-rechargeable batteries
The baby unit runs on four 1.5V R6 AA batteries (not included). We advise you to use Philips LR6
PowerLife batteries or an equivalent type.
Do not use rechargeable batteries, as the baby unit does not have a charging function.
Place batteries in the baby unit if you do not want to use it corded or if you want to be sure of
backup power in case of power failure. Replace the batteries when the baby unit indicates that the
batteries are low (the empty battery symbol flashes on the display and the text ‘Battery low’
appears).
Unplug the baby unit and make sure your hands and the unit are dry when you insert the
non-rechargeable batteries.
1 Remove the lid of the compartment for non-rechargeable batteries. (Fig. 5)
2 Insert four non-rechargeable batteries (Fig. 6).
Note: Make sure the + and - poles of the batteries point in the right direction.
3 Reattach the lid. (Fig. 7)
Note: When the batteries are low, the battery light on the baby unit flashes red.
parent unit
Operation on rechargeable battery pack
The parent unit comes with a NiMh 850mAh rechargeable battery pack.
Charge the parent unit before you use it for the first time or when the parent unit indicates that the
battery pack is low (the empty battery symbol flashes on the display and the parent unit beeps). The
parent unit starts indicating that the battery pack is low 30 minutes before the battery pack
is completely empty.
Note: If the battery pack is completely empty, the parent unit automatically switches off and loses
contact with the baby unit.
1 Remove the lid of the compartment for the rechargeable battery pack (Fig. 8).
2 Insert the rechargeable battery pack (Fig. 9).
Note: Make sure the + and - poles of the battery pack point in the right direction.
3 Reattach the lid (Fig. 10).
EngliSh 11