Philips Avent SCD525 - Manual (Page 20)

Frequently asked questions
This chapter lists the questions most frequently asked about the appliance. If you cannot find the
answer to your question, visit our website www.philips.com/AVENT or call 1-800-54-AVENT
(1-800-542-8368).
Question Answer
What is ECO mode?
How does this mode
help the environment?
The ECO mode has been developed to enable you to reduce your
energy consumption. Monitoring your baby from a small distance
requires less power than monitoring your baby from a large distance.
When you monitor your baby from a small distance, you can activate
the ECO mode. By switching on the ECO mode, your baby monitor
uses less energy and is therefore more enviornment-friendly.
Why don’t both the
power-on light of the
baby unit and the LINK
light of the parent unit
come on when I press
the on/off buttons of
the units?
Perhaps the rechargeable battery pack of the parent unit is empty and
the parent unit is not in the plugged-in charger. Insert the small
appliance plug into the charger, put the adapter of the charger in a wall
socket and place the parent unit in the charger. Then press the on/off
button to establish connection with the baby unit.
Perhaps the non-rechargeable batteries of the baby unit are empty and
the baby unit is not connected to a power outlet. Replace the
non-rechargeable batteries or connect the baby unit to a power outlet.
Then press the on/off button to establish connection with the parent
unit.
The baby unit and the parent unit may be out of range of each other.
Move the parent unit closer to the baby unit, but not closer than
3.5 feet/1 meter.
If the LINK light on the parent unit still does not start to flash, use the
reset function to reset the units to their default settings.
Why does the LINK
light on the parent unit
light up red continuously
and why is the message
‘Searching’ shown on
the display?
The baby unit and the parent unit are out of range of each other. Move
the parent unit closer to the baby unit.
The baby unit may be switched off. Switch on the baby unit.
The ECO mode is switched on, but the operating range is too large.
Move the parent unit closer to the baby unit or switch off the ECO
mode.
Why does the battery
light on the baby unit
flash red?
The non-rechargeable batteries of the baby unit are running low.
Replace the non-rechargeable batteries or connect the baby unit to a
power outlet (see chapter ‘Preparing for use’).
Why does the parent
unit beep?
If the parent unit beeps while the LINK light lights up red continuously
and the message ‘Searching’ is shown on the display, the connection
with the baby unit is lost. Move the parent unit closer to the baby unit.
EngliSh 20