Panasonic BL-WV10A - Manual (Page 152)

16 Troubleshooting the BL-WV10A
152
You cannot use Quick
Setup. Quick Setup will work for a maximum of 8
cameras.
Is the Ethernet cable connected properly?
• If the Ethernet cable is connected properly,
the LAN indicator will be lit green.
Quick Setup can only be performed within 20
minutes of turning on a camera that still has its
default settings (as at time of purchase).
• Turn the camera on again.
When performing Quick Setup on the BL-C30A, is
the camera switch set to wired?
When performing Quick Setup on a computer for
cameras already initialized, is the IP address the
same as that for the BL-WV10A?
No router is displayed,
even though one is
connected. Was the router turned on before the BL-WV10A?
• Turn the router on and wait a minute or more
before turning the BL-WV10A on.
Is the DHCP server option in the router settings
turned off?
• Quick Setup cannot be performed.Launch the
BL-WV10A in normal mode, and manually
perform network settings from the Setup
menu.
Display indicates no
wireless router. This appears when the BB-HGW700A is not
connected.
• Each device is initialized with different
wireless data settings, but can be used as is.
Are the wireless settings for the BB-HGW700A
configured to not use wireless options?
Display indicates that no
wireless router was found. Are the wireless settings for the BB-HGW700A
configured for the 802.11a communications
mode?
• If the BL-WV10A is used as a repeater, use a
communications mode other than 802.11a for
the BB-HGW700A. If the BL-WV10A is used
as an access point, launch in normal mode,
and then manually input the settings in the
Wireless section of the Setup menu.
Issue Causes and Solutions