Panasonic BL-WV10A - Manual (Page 30)

2 Connecting Cameras
30
2.2.5 Placing Cameras
Place cameras after confirming the camera image (see page 28).
1. Disconnect the cameras and place them where you wish to use them.
• Refer to page 6 in this manual as well as the Operating Instructions
included with the camera for proper placement.
2.
Connect all wired cameras to the BL-WV10A.
3.
Set the mode switch on the back of the BL-WV10A to [NORMAL] and turn it
on.
4. Turn on the cameras.
5. Confirm that each camera can be accessed by the BL-WV10A.
• Camera information can be displayed by pressing [DISPLAY] while
monitoring a camera. When placing a wireless camera, refer to the signal
strength displayed on-screen for optimum transmission quality.
Transmission problems can result in connection faults and problems when
monitoring the camera.
Strongest signal Weakest signal No signal
Signal
strength