Philips KX-HCM8 - Manual (Page 20)

Operating Instructions
20
2.3 How to turn on Network Camera for
Installation
Connect the DC plug of the AC adaptor to the DC IN jack and a category 5 straight/
cross cable to the Ethernet port. Connect the AC plug of the AC adaptor to the
power outlet to turn on Network Camera. Ethernet Indicator turns on when the
network is active.
Notes
• AC adaptor is used as the main disconnect device, so ensure that the
power outlet is located/installed near the equipment and is easily
accessible.
• Use only the specified Panasonic AC adaptor PQLV10 (Order No.
PQLV10Y).
• When you set up Network Camera in [Type 3], connect it temporarily in
[Type 1], [Type 2] or [Type 4].
• When the Ethernet Indicator is off, confirm that the Ethernet cable is
properly connected, or PC, Ethernet hub or broadband router is properly
working.
• Thread the AC adaptor line through the hook upward if it is convenient.
Thread the AC adaptor
line through the hook
downward.
Connect a category 5
cable to the Ethernet port.
AC adaptor
Power
Outlet
DC plug