Precor p20 - Manual (Page 71)

Assembling the AMT
21
Threading the Cables
Depending on the model of console you are installing and the
options it includes, you will need to install one or more of the
following cables:
 Television (coaxial with F connectors)
 Power
 Ethernet
Precor recommends threading new cables from the top down,
to take advantage of gravity. A fish tape (a thin metal strip
with a hook or clasp on one end, available from professional
hardware vendors) can be helpful during this procedure.
To thread new cables through the equipment:
1. Select the console power cable (red and black, individual
leads), the Ethernet cable (flat and black), or the
television cable (round and black).
2. Thread the cable through the center column at the front
of the equipment.
3. Guide the end of the cable through the gap at the bottom
of the center column, then attach it to the appropriate
connector on the jack panel. Refer to the following
illustration and table for the position of each connector.
Important: Install coaxial cable using a torque wrench and
torque to not exceed 8 lb-in. If a torque wrench is not
available, install the coaxial cable using a wrench to “snug +
¼ turn.” It is permissible to use a wrench on the internal nut
to aid the tightening process.