Precor p20 - Manual (Page 73)

Assembling the AMT
23
To level the AMT:
1. Gently rock the AMT while standing on one of its foot
plates and grabbing the opposite handlebar. First stand on
the left foot plate and grab the right handlebar to rock the
AMT, then repeat the step while standing on the right
foot plate and holding the left handlebar. If there is any
movement, ask your assistant to tip the unit on its side
while you locate the adjustable feet.
2. Reposition the adjustable feet as needed.
If you want to … Then turn the adjustable feet …
Raise the front end of the AMT Counterclockwise
Lower the front end of the AMT Clockwise
Figure 7: Location of adjustable feet
3. When you are finished positioning the adjustable feet,
place the unit on the floor. Try rocking it again, as
described in step 1, to verify that it is level.
4. To install the rear pedestal, align it over the rear
crosspiece and press it gently into place.
Figure 8: Rear pedestal placement