Polycom SpectraLink DCE201 - Manual (Page 19)

Getting Started
1725-36027-001_C.doc 19
Softkeys
Softkey functions change as the state of the handset changes. Softkeys
are displayed only when they are available to be activated. Softkeys
make usual PBX functions available on the handset. For example, a
call may be placed on hold, the handset may be muted, and a second
line may be activated for an outgoing call or a second call on the same
line may be answered. Calls may also be transferred to another
number, either as a consulted transfer or without consult. Other
handset features (DND, Transfer) may be accessed by pressing the
FCN key.
Number dialing may be specified as alpha or numeric code by
pressing
Start Call plus the MENU key. Select Alpha Dialing if letters and
symbols are to be entered in the dialing string.
Softkey Name Displayed during… Press to…
Answ Answer Incoming call on the selected
line. Answer the call (equivalent to
START key).
Bksp Backspace character Entering a dial number. Delete the character prior to the
cursor position.
Back Back one screen Displaying a menu. Exit the menu.
Dial Dial Call A dial number is being
entered on the selected line. Initiate a phone call to the
entered dial number.
End End Call An active call on the selected
line. Terminate the call without going
back to standby mode.
Favr Favorites Prior to entering the first
character of a dial number. Activate the Favorites menu.
Fwd Forward Definition Prior to entering the first
character of a dial number.
Delete a previously defined
forward destination.
Or initiate definition of a new
forward destination.
Hold Hold In an active call. Place the call on hold. The line
status shows x when the call is
on hold or * when audio is
flowing.
Msg Message Initial dial screen when new
line is selected and a dial
tone is active prior to
entering first character of the
number to be dialed
1 .
Initiate a call to the specified
message center contact address
for retrieval or administration of
voicemail.
1 Appears only if the PROXYn_MAIL_NOTIFY is configured. A message center contact address must be defined for the proxy used by the selected
line.