Pride Mobility 1420 - Manual (Page 22)

22
www.pridemobility.com Quantum Jazzy 1400 Series Rev D May 04
V . C O M F O R T A D J U S T M E N T S
Footrest Angle
You can adjust the angle of the footrest with a hex key. See figure 11.
To adjust the footrest angle:
1. Turn the setscrew clockwise to raise the front of the footrest.
2. Turn the setscrew counterclockwise to lower the front of the footrest.
Controller Position
The controller can easily slide out away from the armrest, or in toward the
armrest. You can also move the controller to the other armrest.
To extend the controller:
1. Use a hex key to loosen the setscrew. See figure 12.
2. Slide the controller into or out of the armrest to the desired position.
3. Tighten the setscrew.
Figure 10. Footrest Height
BOLT, SPACERS, AND NUT
Figure 11. Footrest Angle
SETSCREW
Figure 12. Underside of Armrest
SETSCREW
You can position the controller for either left-hand or right-hand use.
To change the controller position:
1. Unplug the controller connector from the electronics tray. See figure 4.
2. Cut the wire tie that attaches the controller cable to the armrest.
3. Use a hex key to loosen the setscrew under the armrest. See figure 12.
4. Slide the controller out of the armrest.
5. Loosen the setscrew under the other armrest.
6. Place the controller in the other armrest.
7. Tighten the setscrew.
8. Use a wire tie to secure the controller cable to the armrest.
9. Plug the controller connector into the electronics tray.