Pride Mobility 1420 - Manual (Page 41)

41
Quantum Jazzy 1400 Series Rev D May04 www.pridemobility.com
V I I I . C A R E A N D M A I N T E N A N C E
Monthly Checks
n Check that the anti-tip wheels do not rub the ground when you operate the power chair. Adjust them as necessary. See V.
“Comfort Adjustments.”
n Check for extreme wear on the anti-tip wheels. Replace them as necessary.
n Check for drive tire wear. See an authorized Pride provider for repair.
n Check the caster wheels for wear. Replace them as necessary.
n Check the rear forks for damage or fluttering which indicates that they may need to be adjusted or have the bearings
replaced. See an authorized Pride provider for repair.
n Keep your power chair clean and free of foreign material, such as mud, dirt, hair, food, drink, etc.
Yearly Checks
Take your power chair to an authorized Pride provider for yearly maintenance. This helps ensure that your power chair is
functioning properly and helps prevent future complications.
Storage
Your power chair should be stored in a dry place, free from temperature extremes. When storing, disconnect the batteries from
the power chair. See VI. “Batteries and Charging.”
CAUTION! If you fail to store the unit properly, the frame can rust and the electronics can be damaged.
Cleaning Precautions
CAUTION! Never hose off your power chair or place it in direct contact with water. Your power chair has
a painted, ABS plastic body shroud that allows it to be easily wiped clean with a damp cloth.
CAUTION! Never use any chemicals to clean a vinyl seat, as they may cause the seat to become slippery
or dry out and crack. Use soapy water and dry the seat thoroughly.
Tire/Wheel Replacement
If you have pneumatic tires and you have a flat tire, replace the tube. If your chair is equipped with a solid tire insert, then you
must replace the whole wheel assembly. Replacement tires, tubes, and wheel assemblies are readily available through your
authorized Pride provider.
WARNING! To avoid possible injury, be sure that the controller’s power is turned off and the power chair is
not in freewheel mode before performing this procedure.
WARNING! Completely deflate the tire before attempting repair.
Follow these easy steps for a quick and safe repair for both solid and pneumatic tires:
1. Turn off the power to the controller.
2. Set the power chair up on blocks.
3. If you are changing a pneumatic tire, completely deflate it before removing the wheel.
4. Use a socket wrench to remove the drive wheel nut from the center hub of the wheel.