Pride Mobility 1420 User Manual

Page 32

Advertising
background image

32

www.pridemobility.com

Quantum Jazzy 1400 Series Rev D May 04

V I I . O P E R A T I O N

WARNING! Unless faced with an emergency situation, do not use the on/off key to stop the chair. This will

cause the power chair to stop abruptly.

WARNING! Always turn the power off when you are stationary to prevent unexpected movement.

Mode Key

Press the key to change speed setting or to activate the power accessories. See “Speed Settings” or “Power Accessories.”

Speed Setting Indicator

Indicates the selected speed setting.

Power Accessory Indicator

Indicates the selected power accessory. This is for optional

accessories only.

Horn Key

The horn key activates the horn.

Right/Left Turn Indicator Keys

The right/left indictor keys toggle either the left or right turn

indicators. Press once to turn on and press again to turn off.

You can also turn off the selected indicator by pressing the

opposite indicator key or the hazard key.

Light Key

The light key turns headlights/taillights on and off independent

of other indicators.

Hazard Key

The hazard key toggles both indicators at the same time.

You can only cancel this by pressing the hazard key again.

Battery Condition Meter

The battery condition meter is located in front of the joystick.

This is a 10-segment illuminated display that indicates that the

Remote Plus is turned on and also gives the status of the

battery, the controller, and the power chair electrical system.

n Red, yellow, and green lights lit: Battery charged;

controller and electrical system OK.

n Red and yellow lights lit: Charge battery if possible; controller and electrical system OK.

n Red lights only lit or slow flash: Charge battery as soon as possible; controller and electrical system OK.

n Rapid flash of lights: Indicates a fault in the controller or the electrical system.

n Ripple up and down of lights: The joystick was not in the neutral position when the controller was turned on. If you get “ripple up

and down of lights”, turn off the controller, allow the joystick to return to the neutral position, then turn on the controller.

Figure 21. Remote Plus Keypad

Advertising