Philips HTS8000S - Manual (Page 19)

English
19
3139 115 2xxx1
Getting Started
Step 1: Preparing the remote
control
Before you start using the remote
control, pull out the plastic protective
sheet.
To change the battery
●
Pull out the battery compartment and
replace with the battery type LITHIUM
CR2025.
CAUTION!
– Remove battery if it is exhausted
or if the remote control is not to be
used for a long time.
– Batteries contain hazardous
chemical substances, so they should
be disposed of properly.
Using the remote control to
operate the system
1
Aim the remote control directly at the
remote sensor (iR) on the front panel.
2
Press SOURCE button on the remote
to select the mode you wish to control
(for example TV, DISC). The selected
source mode will light up on the LED
panel for a few seconds.
3
Then select the desired function (for
example É,
S, T).
Step 2: Switching on the
DVD system
●
Press SOURCE button repeatedly to
select :
DISC ™ TUNER FM ™ TV ™ AUX
™ DI ™ DISC ....
Switching to Eco Power standby
mode
●
Press STANDBY ON (B).
➜
The display screen will go blank.
➜
The Eco Power indicator will light up
in red.
001-049 HTS8000S-00-Eng 22/04/2005, 04:05 PM 19