Philips HTS8000S - Manual (Page 40)

40
3139 115 2xxx1
English Tuning to radio stations
1
Press SOURCE button until
“
TUNER FM” appears on the display
panel.
2
Press
3 / 4 briefly on the remote.
➜
The display panel will show "
SEARCH"
until a radio station with sufficient signal
strength is found.
3
Repeat step
2
if necessary until you find
the desired radio station.
4
To tune to a weak station, press S /
T
briefly and repeatedly until an
optimal reception is found.
●
If the FM station reception is weak, press
AUDIO to switch the FM mode from
stereo to mono.
Helpful Hint:
– If the FM radio station is transmitting RDS
(Radio Data System) data, the RDS name
will be displayed and stored.
Presetting radio stations
You can store up to 40 FM preset radio
stations in the memory.
Helpful Hints:
– The system will exit presetting mode if no
button is pressed within 20 seconds.
– If no valid frequency is detected during
Plug and Play,"
CHECK ANTENNA" appears.
Using the Plug and Play
Plug and Play allows you to store all
available radio stations automatically.
SUBWOOFER
1 AUTO INSTALL..
INSTALL TUNER 2
1
For first time setup, press SOURCE
to select TUNER mode.
➜
"
AUTO INSTALL PRESS PLAY"
appears.
2
Press and hold 2; (PLAY PAUSE) until
"
INSTALL TUNER" appears on the
display panel.
➜
All the available radio stations with
strong signal strength will be stored
automatically.
➜
Once complete, the last tuned radio
station will play.
Tuner Operations
DVD system’s
display panel
001-049 HTS8000S-00-Eng 22/04/2005, 04:07 PM 40