Operating guide set up the transmitter, Prepare the receiver collar, Step – Petsafe Wireless Pet Containment System PIF-300 User Manual

Page 7

Advertising
background image

www.petsafe.net 7

Operating Guide

Set Up the Transmitter

Important: You may need to move the Transmitter several times before determining the final location.

The Transmitter is located at the exact center of the Pet Area. Place the Transmitter:

• At least 2 feet above the floor located on the ground floor of your home.

• In a dry, well ventilated, protected area.

• In an area where temperatures do not fall below freezing (e.g., garage, shed, closet).

• On a non-metal table or mount on a wall (1A). A mounting template is included on the back of

this guide.

• At least 3 feet from large metal objects, as these items may reduce the size and shape of your

Pet Area (1B).

To maximize your Pet Area, make

sure the Boundary Switch is on

“High” and the Boundary Control

Dial is set to “8” (1C). Plug Power

Adapter into Power Jack and

standard 120-volt outlet. Turn the

Transmitter on.

Wall

Mount

Tabletop

1A

3ft.

1B

BOUNDAR

Y

CONTROL

7

8

Power

Boundary

Switch

Low

High

8

1C

Prepare the Receiver Collar

Your Receiver Collar comes with short Contact Points. Long Contact Points for

pets with long or thick hair are available through our Customer Care Center at

1-800-732-2677. Tighten the Contact Points using the Test Light Tool (2A) one-half

turn beyond finger tight. Check the tightness weekly.

To Insert and Remove the Receiver Collar Battery

Note: Do not install the battery while the Receiver Collar is on your pet.
This Receiver Collar utilizes a replaceable PetSafe

®

battery (RFA-67). This unique

battery is designed to make battery replacement easier and increase water

protection.
To insert the battery, align the symbols on the battery (arrow) and Receiver

Collar (triangle) (2B). Use the edge of the Test Light Tool (2B) to turn the

battery clockwise until the arrow lines up with the lock symbol on the housing.
To remove the battery, turn the battery counter-clockwise using the edge of

the Test Light Tool (2C). DO NOT attempt to cut into or pry open the battery.

Be sure to discard the used battery properly.
A replacement PetSafe

®

battery (RFA-67) can be found at many retailers.

Contact the Customer Care Center at 1-800-732-2677 or visit our web site at

www.petsafe.net to locate a retailer near you.

2A

2B

2C

Step

1

Step

2

Advertising