Petsafe Wireless Pet Containment System PIF-300 - Manual (Page 8)

8 1-800-732-2677
To Set the Static Correction Level
Read all steps before attempting to set
the Static Correction Level.
1. Remove the clear plastic cover with the
edge of the Test Light Tool to expose
the Correction Level Button (2D).
2. With the battery installed, press the
Correction Level Button and release
when the Receiver LED Indicator Light
lights up (2E).
3. The Receiver LED Indicator Light will
emit a series of flashes representing
the Static Correction Level.
4. Increase the Static Correction Level by
pressing and releasing the Correction
Level Button within 5 seconds of the
previous series of flashes.
2D 2E
5. After setting the Static Correction Level, replace the cover to protect the Correction Level Button.
The Static Correction levels increase in strength from 1 to 6. Pushing the Correction Level Button
while the Receiver Collar is on level 6 will cause the Receiver Collar to revert to level 1. Refer to the
Function and Response Table to choose the Static Correction level that best fits your pet.
The Receiver Indicator Light acts as a low battery indicator. The light will flash every 4 to 5 seconds
when battery replacement is required.
Battery Contact Verification
Remove Receiver Collar from your pet. Press the button and verify that the LED light illuminates. If
the LED light does not come on remove the battery. Locate the metal tabs in the battery well. Gently
lift the tabs to ensure that the battery will make good contact. Replace the battery into the Receiver
Collar. Press the button and check that the LED light illuminates.
Function and Response Table
Indicator Light
Response
Static
Correction
Level
Receiver Collar Function Temperament of Pet
1 Flash 1 No Static Correction, Tone Only Initial Training Mode
2 Flashes 2 Low Static Correction Timid
3 Flashes 3 Medium-Low Static Correction Timid or Average
4 Flashes 4 Medium Static Correction Average Energy
5 Flashes 5 Medium-High Static Correction Average or High Energy
6 Flashes 6 High Static Correction High Energy
Flashes once every
4 to 5 seconds
Indicates Low Battery
Over Correction Protection
If your pet enters the Boundary Zone or continues anywhere beyond the Pet Area, this feature limits
the Static Correction duration to 30 seconds.
In the unlikely event that your pet leaves the Pet Area, he will not receive a Static Correction upon
return to the Pet Area.