2 ethernet commands, 1 create ethernet intf, 2 delete ethernet intf – Planet Technology IP DSLAM IDL-4801 User Manual
Page 318: 3 get ethernet intf, 4 modify ethernet intf
IDL series User Guide
318
5.11.2 Ethernet Commands
5.11.2.1 Create ethernet intf
Description:
Use this command to create a physical Ethernet interface.
Command Syntax:
create ethernet intf ifname <interface-name> [ip <ip-address>] [mask
<net-mask>][usedhcp true|false] [speed {auto|100BT|1000BT}] [type
uplink|downlink][enable | disable] [pkttype Mcast|Bcast|UnknownUcast|All|None]
[orl decvalue][duplex half| full|auto] [profilename <profilename-val>]
[mgmtvlanid <mgmtvlanid-val>] [priority <priority-val>] [trfclassprofileid
<trfclassprofileid-val> ] [Ctlpktinstid <ctlpktinstid-val>] [ ctlpktgroupid
<ctlpktgroupid-val> | none ] [mgmtsvlanid <mgmtsvlanid-val>] [m2vmacdbid
<m2vmacdbid-val> |none] [ mgmttvlanid <mgmttvlanid-val> ]
5.11.2.2 Delete ethernet intf
Description:
Use this command to delete a physical Ethernet interface.
Command Syntax:
delete ethernet intf ifname <interface-name>
5.11.2.3 Get ethernet intf
Description:
Use this command to get information about a particular physical Ethernet interface,
or about all the interfaces.
Command Syntax:
get ethernet intf [ifname <interface-name>]
5.11.2.4 Modify ethernet intf
Description:
Use this command to modify physical Ethernet interface configuration.
Command Syntax:
modify ethernet intf ifname <interface-name> [ip <ip-address>] [mask
<net-mask>][usedhcp true|false] [speed {auto|100BT|1000BT}] [type
uplink|downlink][enable | disable] [pkttype Mcast|Bcast|UnknownUcast|All|None]
[orl decvalue][duplex half| full|auto] [profilename <profilename-val>]