Polaris FST Touring - Manual (Page 41)

38
FEATURES
Instrumentation
MFD Settings
MFD settings can be made with the
engine running or with the engine off.
If the engine is off, make sure the stop
switch is pressed down and turn the
ignition key to the START position
briefly to activate the gauge. The gauge
will illuminate for about 90 seconds.
Use the MFD Control Switch (A) to set
the MFD display to your preference.
The rocker switch has a MODE button (B) and a SET button (C).
Standard vs. Metric
The MFD will display either standard or metric units of measurement.
While viewing a screen that displays measurements (MPH, KPH or
temperatures), press and hold the MODE switch until the unit of
measurement changes (about 10 seconds).
Speedometer/Tachometer
The speedometer and tachometer can be viewed in either the analog or
the digital display. If the analog display is set to show speedometer
readings, the digital screen will automatically display the tachometer
(option 1). If the analog is set to show the tachometer, the digital
screen will show the speedometer (option 2).
To change preferences, press and hold the MODE button for three
seconds. When the button is released, the new setting becomes active
and screen colors change. See table below.
Option Analog
Display
Digital
Display
Analog
Screen
Digital
Screen
1 Speed RPM Blue “mph” Blue
Backlight
2 RPM Speed Red “X100rpm” Red
Backlight
A
B
C