Panasonic 35 - Manual (Page 20)

Getting started
10
Rear panel
<Procedure>
1. Plug in the connection cable.
2. Connect the LED head to the connection cable.
3. Remove the protective cap from the LED head.
Set the LED jig in place.
<Reference> Heat dissipation device (aluminium)
(A metal fixture attached to the head)
If the LED head is not fixed to a jig, the LED head can become very hot during irradiation. For this reason, do
not touch the head directly with your hands during irradiation.
The rise in LED temperature depends on the duration
of irradiation time and the interval between irradiations.
If the temperature increases beyond a certain point an
alarm will be generated. In the event of such
overheating, increase the size of the heat dissipation
fixture, or add fins to it.
Warning Warning Warning Warning
Warning Warning Warning Warning
M6 (5mm D)
2-M4 (5mm D)