Connecting external components – Panasonic AG-DVX100AP User Manual

Page 58

Advertising
background image

58

INT(L)

INPUT 1
INPUT 2

CH 2 SELECT

CH 1 SELECT

INT(R)

INPUT 2

INPUT 1

INPUT 2

Connecting external components

$

When connecting an audio component, set
the INPUT1 switch or INPUT2 switch to the
LINE position.
The input level is 0 dBu; the recording level
is adjusted using the AUDIO controls.

$

When connecting an external microphone,
set the INPUT1 switch or INPUT2 switch to
the MIC position.

O

Set the input level (–50 dBu and –60
dBu) using the MIC GAIN 1 and MIC
GAIN 2 items on the setting menu
RECORDING SETUP screen.

O

When mounting an external microphone
on the microphone shoe of the camera
recorder, use the accessory microphone
holder and microphone holder adapter.

O

To supply the signals from an external
microphone to CH1 and CH2, connect the
external microphone to the INPUT2 jack,
and set both the CH1 SELECT and CH2
SELECT switches to the INPUT2 position.
(See page 16)

$

When an external component is to be
connected and its video and audio signals
are to be input to the camera recorder,
connect the camera recorder to the output
connectors on the external component.

$

Conversely, when an external component is
to be connected and the video and audio
signals of the camera recorder are to be
input to the component, connect the camera
recorder to the input connectors on the
external component.

O

If video signals have been input to both the
S-VIDEO IN/OUT connector and VIDEO
IN/OUT connector, the signals of the S-
VIDEO IN/OUT connector take precedence.

O

It is not possible to record the audio signals
if video signals are not input to the S-VIDEO
IN/OUT connector or VIDEO IN/OUT
connector except when performing audio
dubbing.

$

A digital video component equipped with a
DV connector can be connected, and its
video signals, audio signals and time code,
etc. can be transmitted digitally.

O

When an IEEE 1394 cable has been
connected to the DV connector, do not
apply a strong load from outside. Doing so
may damage the connector.

O

Before recording signals from an external
component, check that the video signals are
input.

O

When signals from an external component
are being recorded, do not stop the signal
output at the external component side or
disconnect any of the cables. It may not be
possible for the component to be recognized
when recording is resumed.

6 mm

(XSB4+6FZ)

12 mm

(XSB4+12FZ)

Microphone
holder adapter

Microphone
holder

Advertising