Panasonic KX-TC1220NZW - Manual (Page 38)

Using the Directory
38
1 Press (FUNCTION/EDIT) .
2 While the arrow points to “Save
directory
”, press á (Yes key).
•The display shows the number of stored items
in the directory.
3 Enter a name, up to 15 characters using
the dialling buttons (p. 39).
•To move the cursor, press (*) (←) or (#) (→).
•If a name is not required, press á (Next key)
and go to step 5.
4 Press á (Next key).
5 Enter a phone number, up to 22 digits.
•If you misdial, press Ü. Digits are erased
from the right.
6 Press á (Save key).
•A beep sounds.
•To continue storing other items, repeat from step 2.
•To return to the standby mode, press
(EXIT/CH).
•If a pause is required for dialling, press (REDIAL/PAUSE) to add a pause to a
phone number in step 5. This counts as one digit (p. 47).
•You can exit the programming mode any time by pressing (EXIT/CH).
•If the display shows “Memory is full” in step 2, press (EXIT/CH).
To erase other stored items from the directory, see page 44.
•After the maximum of 30 items has been stored, “Memory is full” is also
displayed.
H
Save directory
Ringer volume
GF H
=Yes
Enter name
Tom Jones
#=
←→ H
=Next
Directory=
20 items
Enter name
#=
←→ H
=Next
Enter phone no.
03987654321
H
=Save
Tom Jones
0987654321
For New Zealand Users:
Your telephone service provider may charge you for a local call when
it is dialled with an area code prefix. If the charge for local call is
unacceptable, only the 7-digits of the local number should be dialled
from your telephone. Do not dial the “0” prefix or the area code digit.