Panasonic SC-EN15 User Manual

Troubleshooting guide, Cd stereo system, Sc-en17 sc-en15

Advertising
background image

1

Panasonic Consumer Electronics

Company, Division of Panasonic

Corporation of North America

One Panasonic Way Secaucus,

New Jersey 07094

http://www.panasonic.com

© 2004 Matsushita Electric Industrial Co., Ltd.
Printed in China

Panasonic Sales Company,

Division of Matsushita Electric of

Puerto Rico, Inc. (“PSC”)

Ave. 65 de Infantería, Km. 9.5

San Gabriel Industrial Park, Carolina,

Puerto Rico 00985

Panasonic Canada Inc.

5770 Ambler Drive

Mississauga, Ontario

L4W 2T3

www.panasonic.ca

RQT7890-P

M1104SM0

Dear Customer

Thank you for purchasing this product.
Before connecting, operating or adjusting this product, please read these
instructions completely.
Please keep this manual for future reference.

These instructions are applicable to the following systems.

SC-EN17 is used in the illustrations unless otherwise mentioned.

Display

System

SC-EN17

SC-EN15

Main unit

SA-EN17

SA-EN15

Speakers

SB-EN17

SB-EN15

Operating Instructions

CD Stereo System

Model No.

SC-EN17

SC-EN15

Troubleshooting guide

Before requesting service, make the following checks. If you are in doubt about any of the check points, or if the solutions indicated in the chart do not solve the problem,
refer to the "Customer Services Directory" on page 8 if you reside in the U.S.A., or refer to the "Product information" on page 7 if you reside in Canada.
In other areas, consult your dealer.

No play.

• The disc isn’t correctly set.

• The disc is scratched or dirty. (Tracks skipped.)

• There is moisture on the lens. Wait for about an hour

and then try again.

MP3 cannot be read

(SC-EN17).

• You may not be able to play MP3 if you have copied a

multi-session disc that has no data between sessions.

• When creating a multi session disc, it is necessary to

close the session.

• The amount of data on the disc is too small. Set the

amount of data to greater than approximately 5MB.

Sound is unfixed,

reversed or comes

from one speaker only.

• Check the speaker connections. (

→ page 2)

No sound or there is a

lot of noise.

• Noise may occur when playing MP3 if recording quality

is poor (SC-EN17).

• Keep this unit away from mobile telephones.

• Turn the volume up.

• Switch the unit off, determine and correct the cause,

then switch the unit on. Causes include shorting of the

positive and negative speaker wires, straining of the

speakers through excessive volume or power, and

using the unit in a hot environment.

Humming heard during

play.

• An AC power supply cord or fluorescent light is near the

cords. Keep other appliances and cords away from this

unit’s cords.

A beat sound is heard

while receiving a radio

broadcast.

• Switch the TV off or separate it from the unit.

A low hum or noise is

heard during AM

broadcasts.

• Keep the antenna away from other cables and cords.

• Keep the AM antenna away from the unit.

The picture on the

television near the set

disappears or stripes

appear on the screen.

• The location and orientation of the antenna are

incorrect.

• The TV antenna wire is too close to the unit. Separate

the antenna wire of the TV set from the unit.

Remote control
doesn’t work.

• Check that the batteries are inserted correctly. (

→ page

2)

• Replace the batteries if they are worn.

– –:– –

• You plugged the AC power supply cord in for the first

time or there was a power failure recently. Set the time.

(

→ page 5)

• The total programmed play time is more than 200

minutes.

Tracks can still be programmed and played.

PGM FULL

• The number of programmed tracks is limited to 24. No

further tracks can be programmed.

NOT MP3

• A CD-ROM disc that is not CD-DA or MP3 format is inserted.

It cannot be played.

ERROR

• Incorrect operation performed. Read the instructions

and try again.

F76

• There is a power supply problem. Consult the dealer.

En

P

PC

This product may receive radio interference caused by mobile telephones during use.
If such interference is apparent, please increase separation between the product and
the mobile telephone.

Advertising