Precor C842i - Manual (Page 17)

Product Owner’s Manual: Club Features 15
Informational Displays (C846i)
The C846i cycle provides information about its use (odometer and
hour meter), as well as software version, error log, and serial number.
In general, you would only access this information if directed to do
so by Precor Customer Support.
These instructions guide you through all five informational displays.
Pressing the ENTER key moves you through the displays. To exit,
press the RESET key at any time.
Viewing the Odometer
1. At the Precor banner, press the following keys in sequence and
without pause:
RESET, 6, 5
Numbers appear on the display as you press the associated key.
The odometer value (the total revolutions) appears on the display
followed by the word REVOLUTIONS.
2. When you are ready, press ENTER to move to the next display
(hour meter).
Viewing the Hour Meter
HOUR METER appears followed by the number of hours that
the unit has been in use. The cycle tracks the elapsed minutes,
but the value that appears is truncated to the nearest full hour.
3. When you are ready, press ENTER to move to the next display
(software version).
Viewing the Software Version and Part Numbers
SOFTWARE VERSION appears for two seconds. UPPER APP
then appears followed by the upper board application software
part number and version (for example, 48181-350).
4. To see the upper boot and lower boot application software
version, use the arrow keys. If needed, you can move through all
three—upper board, upper boot, and lower board—using the
arrow keys.
5. Write the numbers below. You will need these numbers when you
call Customer Support with display-related questions. This
information will help rule out any software-related problems:
Upper Application P/N: ___________________
Upper Boot Software P/N: _____________
Lower Application P/N: ___________________
6. When you are ready, press ENTER to move to the next display
(error log).