Panasonic TU-HDT206A - Manual (Page 12)

Operating Instructions
TU-HDT206A
12
1: TEN,
2: ABC,
3: SBS,
5: TEN Regionals,
6: SEVEN Regionals,
7: SEVEN,
8: NINE Regionals,
9: NINE.
Pushing the Cursor Up/Down buttons can be used to display the banner, and
then change the banner to the next channel banner information. To view the new
channel, the OK button must be pushed while the banner is displayed.
Use to toggle between current channel and previously watched
channel .
5.5 Audio Mode Selection
Australian broadcasters transmit MPEG
and/or Dolby Digital audio with all programs.
The audio mode default setting is MPEG.
This can be changed by pressing the
AUDIO
button on the remote control to display the
Audio OSD. The Audio OSD shows on
screen the available soundtracks. The
currently played track is highlighted. Use the
cursor up/down buttons to change the
selection. The OSD will disappear in a few
seconds or Exit will remove the OSD.
5.6 SD Picture Format Selection
During the installation, the digital receiver
aspect ratio is automatically set to
widescreen 16:9 when a HD format video is
selected as the output format. With a SD
output format, the aspect ratio is set to 4:3.
The aspect ratio can be changed, in SD,
between widescreen 16:9, centre cut for 4:3,
or letterbox. The Display Aspect can be
changed using the remote control by
pressing the aspect button to bring up the
OSD. The OSD will have one aspect selection highlighted. To change the display
aspect, push the aspect button until the desired picture aspect is selected. The OSD
will disappear after a few seconds. This function is the same as the SD Picture
Format setting on page 15.