PictureTel LIVE GATEWAY 3.1 - Manual (Page 16)

Installing the LiveGateway Software
Overview
To install the LiveGateway software, use the Setup program described in this section. The LiveGateway Setup
program lets you:
• Install the LiveGateway software
• Configure the LiveGateway board(s)
• Edit Configuration Information
This section contains the following information:
• Before You Begin
• Upgrading from a Previous Version of LiveGateway
• Installing the LiveGateway Software
• Configuring the LiveGateway Boards
• Entering LiveGateway Configuration Information
• Running the LiveGateway Configuration Utility
• Starting the LiveGateway Application
• Stopping the LiveGateway Application
• Accessing the LiveGateway Audio Clip Recorder
• Deinstalling LiveGateway
Before You Begin
Perform the following tasks before installing the LiveGateway software:
• Identify available IRQ and I/O address settings and reset the board DIP switches if necessary.
• Install the LiveGateway board(s).
• Prepare the LiveGateway configuration information.
• Make sure LiveManager version 3.1 (or other H.323 gatekeeper) has been installed on your network.
• Obtain the LiveManager's IP address or name.
Upgrading from a Previous Version of LiveGateway
It is not necessary to deinstall a previous version before you install the LiveGateway software. All configuration
information from a previous version will be maintained. When installing over a previous version of
LiveGateway, the existing install directory is preserved. However, you may need to enter a
Gateway Prefix and
a Dialing Prefix (new to LiveGateway versions 3.0 and later).
Note: Stop the previous LiveGateway Service before installing a new version.