Panasonic KX-FLB753HK - Manual (Page 4)

Safety instructions
- 4 -
CAUTION:
Laser radiation
L
The printer of this unit utilises a laser. Use of
controls or adjustments or performance of
procedures other than those specified herein
may result in hazardous radiation exposure.
Fuser unit
L
The fuser unit is inside of the unit and gets
hot. Do not touch it when removing the
jammed paper or cleaning the lower glass.
Toner cartridge
L
Be careful of the following when you handle
the toner cartridge:
–
Do not leave the toner cartridge out of the
protection bag for a long time. It will
decrease the toner life.
– If you ingest any toner, drink several
glasses of water to dilute your stomach
contents, and seek immediate medical
treatment.
– If any toner comes into contact with your
eyes, flush them thoroughly with water,
and seek medical treatment.
– If any toner comes into contact with your
skin, wash the area thoroughly with soap
and water.
Drum unit
L
Read the instructions on page 13 before you
begin installation of the drum unit. After you
have read them, open the drum unit
protection bag. The drum unit contains a
photosensitive drum. Exposing it to light may
damage the drum. Once you have opened
the protection bag:
–
Do not expose the drum unit to light for
more than 5 minutes.
– Do not touch or scratch the green drum
surface.
– Do not place the drum unit near dust or
dirt, or in a high humidity area.
– Do not expose the drum unit to direct
sunlight.
Static electricity
L
To prevent static electricity damage to the
interface connectors (parallel and USB), ADF
jack or other electrical components inside the
unit, touch a grounded metal surface, such as
the metal part under the parallel interface
connector before touching the components.
Caution:
The fuser unit is inside of the unit.
Do not touch the bottom of this
cover. It is very hot.
Metal part